Headphone maintenancemaintainance

After getting a headset, the first thing we need to do is to open the headset. I believe everyone will know the reason for this. We can enjoy it after the praise is turned on, but is it all good as long as the praise is turned on? The answer is no, the quality of some headphones themselves is very good, it is because we are usually careless in use that makes our beloved headphones premature Die! The following is a common situation in the process of repairing headphones, and I will give you some maintenance suggestions!

1. It is best not to wear headphones while sleeping. It is absolutely impossible for ordinary people to stay still overnight. After a long time, the headphone cable is either wrapped around the neck or the two wires are twisted together like a twist. Some large headphones even have their shells crushed. The beams of 100 and 200 are also vulnerable at the beginning! If some friends say that I can't sleep without listening to music, then it is best to hang the headphones, that is, above your head, and use a rubber band to tie the headphone cable to the head of the bed. When you fall asleep, if you tilt your head, the headset will be "pulled" down, no matter how you turn over, it will not be pressed! The advantage of using a rubber band is that it acts as a buffer when pulling the earphones!

2. Wipe off sweat, etc. from the earphone cable after using the earphones. These things secreted by the human body, containing oil or something, are invisible killers of wires, such as e2c at the bend of the ear. Over time, the wire will age and eventually lead to cracks and breaks.

3. It is best not to smoke while using the headset. When everyone is not careful, whether it is the earphone shell or the earphone cable is hot, can you not feel bad for hundreds of thousands of oceans? ? ? In addition, soot will enter the earphone shell and stick to the diaphragm, and the sound will not be right after a long time.

4. Be sure to turn down the volume before use. If the volume of your output device is too loud, it will not only shock the ears, but also fold the diaphragm. In severe cases, the voice coil of the headset will be burned.

5. Keep headphones away from strong magnets. The magnetism of the unit will decrease, and the sensitivity will decrease over time!

6. Keep the earphones away from moisture. The pads in the headphone unit will rust, the resistance will increase, and your headphones will be biased.

7. plug part. Some friends like to put mp3 or something in their trouser pockets. The outlet part of the plug is easy to fold, and it will break after a long time.

8. Do not disassemble. I'm so curious, so let's take a look. Some earphones are difficult to disassemble. The mx500 cannot be disassembled without special methods. Even if you disassemble 80%, it will be broken. If the small 2 is opened, the casing may be damaged, or there will be partial sound. The 888 and 808 are ok, it is easier to get it.

9. It is best not to use it outside in winter. It is cold in winter, the wire is hard and brittle, and excessive bending can easily break the wire. Do not heat the headphone wire at this time, as high temperature will accelerate the aging of the wire.

10. Keep away from chemicals. The paint on the earphone shell is very dissolved in organic chemicals, and it will not look good if it is stained.